Messages

1

General Mach Discussion / Re: Digitize led keeps flashing

« on: May 07, 2015, 12:00:17 PM »

I am looking for a good script for x and y centering.  Can you post your script?
Ed123

2

General Mach Discussion / Re: Dimensions twice what they should be

« on: May 22, 2013, 07:38:41 PM »

Thanks Bret.  Will give it a try

3

General Mach Discussion / Dimensions twice what they should be

« on: May 22, 2013, 06:13:13 PM »

I have calibrated all axes and they measure what I put into the software.
However, when running a simple rectangle program the dimensions are twice what they should be.
Any suggestions as to how to correct this.\?

4

General Mach Discussion / Re: Printer port

« on: May 19, 2013, 07:58:07 PM »

No.  I double checked the specs and it is a 32 bit computer.

5

General Mach Discussion / Re: Printer port

« on: May 19, 2013, 07:29:58 PM »

Yes, the Port is set at 0x378.
The motor outputs are x=2. y=4, z-6
input signals are x=3, y-5, z=7

the Dir LowActive are all green as well as step low Active.
Step port and Dir Port are all set at one.

6

General Mach Discussion / Printer port

« on: May 19, 2013, 03:01:42 PM »

I downloaded Mach3 as instructed and did the reboot before using Mach3.  However, when I go to tune the axis Mach3 does not allow me to select the axis I wish to set.  Also when in the program option I cannot jog the axes.  I assume that the printer driver is not loaded in the computer.
The computer is a refurbished Dell OptiPlex Gx620 with windows 7.   Is there a driver I can download to fix this Problem?