Hello Guest it is March 28, 2024, 11:59:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SigR

Pages: 1
1
CS-Lab / Re: First impressions of CS-Lab products
« on: July 02, 2013, 07:48:21 PM »
Hi All,
I recently hooked up the CSMIO/iP-M.  Have had success on several big jobs.  Couple times though I've had a "lost connection to CSMIO" show up on Mach3. 

Last night I went home with the system halted in the middle of a job that has millions of lines of code.  Halted but not turned off.  At 1am there was a "time out" error that led to losing the connection.  Once the connection was lost the controller no longer had control and the motors ran to the end of the table and just kept on pushing as the limit switches were not regerstering.

Now I can not get the CSMIO and Mach3 to connect.  The little yellow light next to the ethernet cable is on and the inputs that are connected show up slightly illuminated when first turned on but then fade out.  Don't know if the CSMIO is damaged or if there is some other reason it will not connect with Mach3.

Any suggestions would be helpful.
Thanks

Pages: 1