Messages

1

General Mach Discussion / Re: Removing pierce delay from mach3 not possible.

« on: May 10, 2013, 10:43:30 AM »

Thanks for the link. Very good read. I will look into these methods for sure 

2

General Mach Discussion / Removing pierce delay from mach3 not possible.

« on: May 08, 2013, 09:20:54 AM »

Hello. I'm having a problem with removing pierce delay in Mach3 plasma. I use sheetcam for generating the gcode. I need the pierce timer completely gone for the laser application that i'm using at the moment.

What i have tried:

- Making sheetcam pierce delay = 0s
- Manually removing pierce delay from the gcode file (setting G04 = 0 or just remove it completely)


Any advace would be much appreciated. And i apologize if i posted this in wrong forum section.