Hello Guest it is October 04, 2022, 12:57:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Johnjackson622

Pages: 1
1
Well fella's my tech guy switched out our towers and all seems to be working fine now, cross your fingers. I do thank you all for helping out. If I have any other questions I will be sure to ask you guys since you all seem knowledgeable with these programs.

Thanks,
John

2
Is there any other programs that might work with my 3040T triaxial engraving machine? The command codes my machine can read are g-code/.nc/.ncc/.tab/.txt.

thanks,
John

3
I did install both programs at the same time, and when ever I open lazy cam I load from the mach3 screen.

thanks,
John

4
Both of my programmes show that i am licensed. Any other suggestions?

Thanks,
John

5
General Mach Discussion / Have a few problems, need some help please.
« on: April 24, 2013, 09:05:17 AM »
I am using Mach3 with lazycam. I have the license for both of them. Now here are the problems:

1) I can not get lazycam to post a g-code into Mach3. It keeps showing the message "No Mach3 found running". How can I fix this?

2) I started to load my g-code manually from mach3 and that's fine except that whatever I loaded only about half or so would show up. I have noticed that my g-code only went to 5000 lines. So i uninstalled both Mach3 and lazycam then reinstalled them. Now my g-code limit seems to be only 2500 lines.

I am no where near an expert with these programmes. I have went through the entire lazycam manual and also the mach3 manual i was given when I bout the program. If anyone could help I would greatly appreciate it.


Thanks,
John

Pages: 1