Messages

1

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: October 14, 2013, 08:21:58 PM »

Is the speed the jog and step increments?

2

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: October 14, 2013, 03:09:58 PM »

Hi Ger

I have been try to set up my machine with the x y probing. I think I have a setting wrong somewhere. When I hit the y- button ot will start to move in that correct direction but it is at a rapid rate. The same happens on the x+ direction. I have my job rate 00% and my step increment rate at .01. Is there anything else I should check.
They are on the left side below the buttons.

3

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: October 09, 2013, 09:25:42 PM »

and this will give me the zero location that I am looking for

4

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: October 09, 2013, 09:02:34 PM »

I am looking for some advice on probing. I have attached a diagram of what I am trying to do.

5

Newfangled Mill Wizard / Re: Tool Path Still Not Displaying

« on: August 07, 2013, 10:01:10 AM »

Thanks Ron

I just emailed them the request.

Mark

6

Newfangled Mill Wizard / Re: Tool Path Still Not Displaying

« on: August 06, 2013, 08:06:27 PM »

hi guys I just down loaded the newest update v1.0.11 and installed on my computer that I had the bought version on it. when I goto help it says I have the demo version. I had asked Ron how to install a new version an I thought I just had to install over it. what do I do to get this new version under my correct account so I can see the tool paths?

I just reloaded old file set up I have the licensed version working again. how do I install the update?

7

Newfangled Mill Wizard / Re: Tool Path Still Not Displaying

« on: July 31, 2013, 12:00:17 PM »

What version has the fix for my issue that you helped me with above?

Thanks

Mark

8

Newfangled Mill Wizard / Re: Tool Path Still Not Displaying

« on: July 30, 2013, 08:55:35 PM »

Hi Ron

I see there is a new version of the newfangled program. I have purchased a version from you already how do I install the update to my system?

9

Newfangled Mill Wizard / Re: Tool Path Still Not Displaying

« on: July 26, 2013, 01:19:44 PM »

ok great thanks for the help

10

Newfangled Mill Wizard / Re: Tool Path Still Not Displaying

« on: July 26, 2013, 10:25:52 AM »

Thanks for looking into this for me