Hello Guest it is December 05, 2021, 10:19:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - RDeVries

Pages: 1
1
Hello,

Has anyone converted a Probotix Fireball Comet to MACH3 from EMC2?

I was told that MACH3 couldn't run this little table due to the dual Y axis steppers.  I had a Plasmaroute table with a dual Y axis stepper and MACH3 didn't have any issue with it.  What I am hoping for is that someone has a configuration file I could try.

https://www.probotix.com/FireBall_Comet_cnc_router/

Thank you,

Pages: 1