Hello Guest it is April 20, 2024, 07:37:10 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - aokucu

Pages: 1
1
General Mach Discussion / Re: Configuring Mach3 For Plasma
« on: April 04, 2016, 01:49:52 PM »
Plasma cutting table and control electronics shouldn't have electrical contact in no way. Ground your your cutting table wery well. Electrically isolate your switches,motors etc. And use coaxial cable. Ground your coaxial cable and control electronics box together on a seperate ground.

Pages: 1