1
General Mach Discussion / Mach 3 620 oz motor tuning? NEED HELP!!!
« on: April 08, 2013, 11:59:44 PM »
Hello, I'm new amd trying to figure out how to tune my 620 oz stepper motors to mach 3 for my plasma table.
I ordered a gantry from precision plasma and electronics from candcnc. I have the 620 oz motors. The gears I'm using measure 11/16 overall. There are15 teeth on the Gears.
I've been trying to figure out the math and been confused. I've got it close on mach but still off a bit.
Can anyone help me out for the settings on the tuning screen? So my gantry moves the correct measurements
I ordered a gantry from precision plasma and electronics from candcnc. I have the 620 oz motors. The gears I'm using measure 11/16 overall. There are15 teeth on the Gears.
I've been trying to figure out the math and been confused. I've got it close on mach but still off a bit.
Can anyone help me out for the settings on the tuning screen? So my gantry moves the correct measurements