Messages

1

General Mach Discussion / Re: Refurbed IBM ThinkCentre = bad parallel port for mach3

« on: March 11, 2012, 01:30:20 PM »

thank you for your advice.  I did the same thing with the ibm thinkCentre from Tiger Direct.  Thanks again.  Cleve

2

General Mach Discussion / stepper motors loose steps when cold

« on: May 05, 2007, 09:58:41 PM »

my 1200 oz in stepper motors don't run worth a damn when I first turn them on.  They loose steps all over the place.  I'm running mach 3 mill, gecko 201's. After I run them for a while, same speed they run just fine.  Anyone have any ideas.  Any thoughts would be most appreciated.  Thanks Cleveis