1
G-Code, CAD, and CAM discussions / Re: multipass wizard
« on: May 11, 2013, 10:16:18 AM »
So just an update on this. I've been quite busy so not had much time to look at this
I've created a sub routine and saved it in the sub folder, this basically contains the multipass data which i've re-ordered so it cuts the same part one after another.
I then went to create a file to call the subroutine with axis set using g52, i've done this 3 times for testing and on screen it looks to work perfectly, 3 of the same objects lined up next to each other. But if i cycle start offline it will only cut the original offset 3 times despite displaying it in 3 different area's
G52 X0
m98 (3bolt.tap)
G52 x9.8
m98 (3bolt.tap)
G52 x19.6
m98 (3bolt.tap)
M30
M30
I'm sure it must be something pretty simple?
I've created a sub routine and saved it in the sub folder, this basically contains the multipass data which i've re-ordered so it cuts the same part one after another.
I then went to create a file to call the subroutine with axis set using g52, i've done this 3 times for testing and on screen it looks to work perfectly, 3 of the same objects lined up next to each other. But if i cycle start offline it will only cut the original offset 3 times despite displaying it in 3 different area's
G52 X0
m98 (3bolt.tap)
G52 x9.8
m98 (3bolt.tap)
G52 x19.6
m98 (3bolt.tap)
M30
M30
I'm sure it must be something pretty simple?