Brett, here is what I have found, trying to do some troubleshooting ..
- when MACH 3 is not running, I get "System Excellent" under the driver test. ( this is with or without the controller box powered on )
- When mach 3 is running , with or without the controller powered on, the test then comes back as " pulsing too fast "
I have my Kernel speed set to 25K also ...
what i did nottice also is that if i set the kernel speed to the highest and try and move the motors around ,the will skip the same way as the do when running a job .. they dont do this when manually moving when set at 25K .. but it pops up here and there every 15 - 20 min when ruining a job
I can't go any lower in the timeing . im not sure where to go from here :\
thanks for the reply !
Voy