Hello Guest it is December 01, 2021, 02:31:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JiiPee

Pages: 1
1
General Mach Discussion / Re: Tangential control +-360 degrees
« on: September 24, 2014, 03:09:55 AM »
We assembled pneumatics and heating element wires so that over 720 degrees turning is possible.

Way to do this, is buy good enough CAM-software where you can limit rotating axis.


2
General Mach Discussion / Tangential control +-360 degrees
« on: October 14, 2013, 06:52:03 AM »
Hello

I use tangential control but I have wires and pneumatics going to rotate axis.

I use 2.5D cam and I cant´t get A axis values.

Problem is that tangential control is turning too much.  Wires and pneumatics is rotating to axis.

Is there any possibility to program tangential control so that it is not rotating over 360 in same direction?   

3
dspMC/IP Motion Controller / Re: G00 problem with mach3
« on: March 17, 2013, 11:43:05 AM »
Problem solved.

Problem was I max error.

So if I put something else than 0 to I max error machine works strange with G00 command.

4
dspMC/IP Motion Controller / G00 problem with mach3
« on: March 11, 2013, 04:55:58 AM »
I have a problem with G00 Command in Mach3 with DSPMC. For example i give G00 Z1, The Machine goes
0,62 and on the DRO i can see 0,62 - but i wanted to have 1 mm. Nevermind what Speed. This is
always
when I use G00. If i give G00 Z5 then machine goes to 4,62 mm. It seems that machine is about 0,1
seconds without PID loop and in this time Z travels down 0,38mm.

If I drive axis from DSPMC plugin gonfig it works fine.

If I reset Z counters from plugin control, VITAL DSPMC status Z drops every time 0,38mm.

I tried to push Y axis while giving g00X0, same happens to Y axis it will lose about 0,1mm
every g00.

It does not matter if I give G00X,Y or Z.

My config is:

DSPMC  7762S

Mach3 R3.043.066

DSPMC with latest firmware from vitalsystems website and mach3 plugin from same file.

Omron U-series servos with ballscrew from IA corporation.

Servos is analog input and speed mode.

Pulses 2000/revolution.

5
Mach3 and G-Rex / Re: VERY BIG PROBLEM with G00 by Mach3 with Grex100
« on: March 11, 2013, 04:48:44 AM »
Hello

I have same problem with DSPMC and omron servos. How this is solved?

Pages: 1