1
General Mach Discussion / Re: Question about Mach3 Stepper Motor Tuning. Still a few Rough Spots
« on: March 08, 2013, 11:50:41 AM »
I am currently trying to tune the step motors on my machine. The problem I'm having is the motors on all 3 axis have negative rotation, however, positive rotation is intermittent on all 3 axis. A pulse is going to each of the motors during the positive rotation movement, but does not continue to run the motor. If this only happened on a single motor, I would think the problem was mechanical.
Your help would be most appreciated.
Your help would be most appreciated.