1
General Mach Discussion / Re: Problems saving Gcode from write wizard
« on: December 30, 2015, 10:57:01 PM »
Thats it. I just opened mach, checked and it was set to Inc by default.
After I create a file with the write wizard, I checked and it had changed to absolute.
But that seems opposite of what you wrote above. I get circles when the IJ mode is set to Inc. Absolute works like it should. I even changed the IJ setting back and forth a few times with the same code loaded to verify.
Thanks! Everything is working like it should now.
After I create a file with the write wizard, I checked and it had changed to absolute.
But that seems opposite of what you wrote above. I get circles when the IJ mode is set to Inc. Absolute works like it should. I even changed the IJ setting back and forth a few times with the same code loaded to verify.
Thanks! Everything is working like it should now.