Hello Guest it is March 29, 2024, 07:41:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nanoer

Pages: 1
1
Hello, This is Tai. I just registed as a member of the forum. I am an Industrial Design Engineer work and live in San Francisco Bay Area. I have about 4 years experience in setting up and maintening open loop Mach 3 on numerious CNC routers or destop mills. But I think I have come to a point where I should start looking into Closed-loop setting so I joint this forum in hoping to meet some talents and can give me some guidence on what to look into or avoid for closed-loop machine setting. As for my hobby, Photography is always within me. I have been dreaming lately of building a panning device driven my Mach 3!

Thanks,
Tai Chung

Pages: 1