Hello Guest it is December 05, 2021, 10:06:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fireneuf

Pages: 1
1
General Mach Discussion / Re: +y multy pass issue
« on: February 02, 2013, 03:05:47 PM »
I will check on monday thanks

2
General Mach Discussion / +y multy pass issue
« on: February 02, 2013, 11:56:34 AM »
+ y issue  doing multy-passes for depth, everything works fine first pass, start of second pass machine plunges down to correct depth but jogs y + about .093125 runs pattern correctly offset from original, next pass starts an additional.093125 to correct depth. It is like steps down the plunge rather then straight down. It look like it is loosing the home position of y for every plunge cut +.093125 Thank you for your help.

Pages: 1