Hello Guest it is March 28, 2024, 08:57:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dpcwright

Pages: 1
1
General Mach Discussion / Re: Syil X7 and Mach 3
« on: March 20, 2014, 07:35:00 AM »
I have reloaded everything -Mach 3 - the syil profile and the smooth stepper driver and hey presto it all works
There must be a gremlin in my computer
Thanks very much for your help and pointing me in the correct direction
David Wright

2
General Mach Discussion / Re: Syil X7 and Mach 3
« on: March 19, 2014, 11:49:38 AM »
Hood
This is the xml file from the Mach 3 directory, There are of course 2 other xml files -one labelled Mach 3 turn and the other Mach 3 mill - but I am assuming that these are not the ones you need
Thanks
David Wright

3
General Mach Discussion / Re: Syil X7 and Mach 3
« on: March 19, 2014, 10:28:12 AM »
Hood
Thank you for your response - the xml file I use is as the one I posted - this is the one given to me my Syil
I load this and then Mach 3 asks me about the smoothstepper  and I load that - then nothing happens
David Wright

4
General Mach Discussion / Syil X7 and Mach 3
« on: March 18, 2014, 08:11:37 AM »
I have a syil x7 cnc milling machine which has stopped working.
I have not used it for six months due to illness
I load Mach 3 and use the profile which I was supplied with by Syil,(attached below) I then load the smart stepper and then cannot clear the Estop, if I activate the actual machine e stop and reset it I can then clear the estop in Mach 3 however if I run any G code the machine does not operate at all.
I confess to being a complete novice with cnc so please treat me gently but I really need some help

5
General Mach Discussion / Re: Hall of shame
« on: May 27, 2013, 05:21:55 AM »
Well after checking with Scott it appears that my licence is a valid bona fide one after all - so not all chinese machinery is supplied with pirated licences

6
General Mach Discussion / Re: Hall of shame
« on: May 22, 2013, 06:18:17 AM »
I have bought a chinese milling machine via the UK importer - It came with a licence for Mach3. How do I know if this is a genuine licence or pirated?

David Wright

Pages: 1