Hello Guest it is October 14, 2019, 10:00:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - aeroxtremo

Pages: 1
1
HOLA, en config, voy a port and pin, y en imputsignal activo thcup tchdown?

2
hi, the query is whether it is possible to enable that when the mach is executing a program code can be operated by hand in between the Z axis jog para PANTOGRAFO used in oxyfuel UN, and to correct manually height while cutting torch. thanks

3
hola, la consulta es si existe la posibilidad de habilitar que cuando el mach se encuentra ejecutando un codigo se pueda manejar en forma manual por medio del jog el eje Z para utilizar en un pantografo de oxicorte, y poder corregir manualmente la altura de la torcha mientras esta cortando. Gracias

Pages: 1