Hello Guest it is March 28, 2024, 10:40:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - anant

Pages: 1
1
ok ok no problem I will not...

2
General Mach Discussion / Re: Having problem in reducing production time
« on: January 06, 2013, 03:00:06 AM »
Thank for the replies, what i was trying to do is increasing the velocity per units setting in motor tuning tab and not changing the acceleration setting.

What is the good setting or ratio between velocity and acceleration setting in mach3.

Will increasing the acc settings will also reduce time?

3
    
I am using cam softwares like aspire and artcam to design and generate gcodes..there are some designs which take 7-8 hrs to cut .. so there
is anyway to split gcode into 2 parts or more..

4
General Mach Discussion / How to split gcode into 2 parts or more..
« on: January 06, 2013, 01:40:05 AM »
I am using cam softwares like aspire and artcam to design and generate gcodes..there are some designs which take 7-8 hrs to cut .. so there
is anyway to split gcode into 2 parts or more..

5
General Mach Discussion / Re: Having problem in reducing production time
« on: January 06, 2013, 01:23:18 AM »
Actually i m using photovcarve for photo engraving with 2.5mm deep cut and in all the feeds time is the same...

6
General Mach Discussion / Having problem in reducing production time
« on: January 03, 2013, 12:39:19 PM »
I am having a problem regarding velocity and acceleration figures, how to reduce the time can anybody help?

 What I am trying to do is ,I cut the same job 3 times with different feeds: 100 IPM, 125 IPM, 150 IPM but the total time taken for all 3 setup is 40 min. There is no
difference in time. Is there anything which I am doing incorrectly.

is there something related to motor tuning tab?

PLEASE HELP

Pages: 1