1
General Mach Discussion / Re: problem settings -need help
« on: February 04, 2013, 09:23:56 AM »
Brett,
yes, the ballscrew pitch is 5mm per rev.i checked the driver manual and there is a 10 microsteping setting . so i will have 200*10(microsteping)/5(pitch)=400 steps/1mm
with taht way everything is rounded to 0.01 mm
the problem with the max speed is not fixed. the slow jog setting is set to 100% so if i press the shift or not doesnt matter. i am still limited to 72 units /min max speed.
i do not know what am i missing.
also noted that i cannot jog simultaneusly x and y or z axis. is that normal?is there any setting for jogging both axis the same time?
question about diagnose screen. can i simulate a limit switch signal by pressing a key? there is a simulation button in that diagnose screen but does not seems to do annything..
thanks!
yes, the ballscrew pitch is 5mm per rev.i checked the driver manual and there is a 10 microsteping setting . so i will have 200*10(microsteping)/5(pitch)=400 steps/1mm
with taht way everything is rounded to 0.01 mm
the problem with the max speed is not fixed. the slow jog setting is set to 100% so if i press the shift or not doesnt matter. i am still limited to 72 units /min max speed.
i do not know what am i missing.
also noted that i cannot jog simultaneusly x and y or z axis. is that normal?is there any setting for jogging both axis the same time?
question about diagnose screen. can i simulate a limit switch signal by pressing a key? there is a simulation button in that diagnose screen but does not seems to do annything..
thanks!