Messages

1

General Mach Discussion / Re: Rotate Mill head

« on: October 25, 2014, 12:22:17 PM »

Thanks for the responses.  A horizontal mill profile looks to be the way to proceed.
Cambam had an issue with dxf files in the ZY plane anyway.  (can't handle arcs)


Thanks again,
William

2

General Mach Discussion / Rotate Mill head

« on: October 22, 2014, 11:09:14 PM »

I need to mill a hole on the Z-Y plane, with X being the depth.  Is this normally done in cam or do you switch the axis in Mach?  Trying to wrap my head around this one, any help would be appreciated.

3

Works in progress / Re: Mach3 2010

« on: March 30, 2013, 10:42:59 PM »

Nevermind... F500 did the trick

4

Works in progress / Re: Mach3 2010

« on: March 30, 2013, 05:53:24 PM »

My step jog speed is slow where can I change it? 
Ie.. My jog speed is at 100%, I have it set to step jog 1", it jogs the 1" at about 10% jog speed.

Thanks
Bill