Hello Guest it is November 18, 2019, 09:53:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hellmill

Pages: 1
1
General Mach Discussion / Re: Steppers making noise but shafts not rotating
« on: December 31, 2012, 03:01:49 PM »
add more current

2
Hello, My name is Cal
 First time here, looking for a bit of instruction. Have 3 stepper motors and controllers tuned 1 and runs slow but quiet, tried to tune second no joy, so used same tuning as the first still no joy, could the motor be bad? noisy and not smooth.
Using Camsoft software, set steps 1:50 1.8deg 20,000 accel and decell, 3,290,000 first runs fine, no noise, second is noisy, any ideas?
My motors are 85BYGH 450c-03a
My controllers are CW260C microstep

Pages: 1