Hello Guest it is March 28, 2024, 07:26:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SAWMILL CREEK

Pages: 1
1
I PLAYED AROUD WITH THOSE SOFT LIMIT SETTINGS, ERROR" SAID HOME SWITCH ACTIVE, FIX, THEN" SO I PLAYED WITH TOSE SETTINGS IN HOME AND SOFT LIMITS UNDER CONFIG TAB. NEVER MESSED WITH PLASMA OR AIR OR THC SETTINGS. WHEN I STARTED WITH ERROR MY TORCH WOULD NOT LOWER BUT TO WHITIN ABOUT  ONE INCH OF METAL. I'm LEARNING AS I GO BUT I'VE GOT A LONG WAY TO GO

2
I am having trouble with I believe the soft limit settings. I was getting error messages Home switch active. I have been playing with the settings, and have finally got the torch to drop down to the metal, and cut but It will not fully cut !4ga. My plasma is set correct along with voltage. Been cutting for weeks at these settings on same ga metal, no problems. Just started having problems with mach 3 error messages. X and W DRO stay red, but Z goes green and cannot get it to change back to red unless I reload Mach. machine came set up ready to run. Read every Mach manual and watched tons of tutorial, can't figure it out.

Pages: 1