Hello Guest it is March 28, 2024, 06:04:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dajie

Pages: 1
1
General Mach Discussion / Re: CNC4PC C11 question
« on: December 20, 2012, 10:37:32 PM »
hello group,
i have a Denford CNC lathe that im trying to convert to mach3 but im not sure of the type BOB to use. could someone advise on this?

thanks in advance

Pages: 1