Hello Guest it is March 29, 2024, 05:52:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Javert

Pages: 1
1
General Mach Discussion / Re: Assigning miscellaneous M codes.
« on: December 18, 2012, 03:46:03 PM »
Thanks Hood. I'll do some research into Macros.

2
General Mach Discussion / Assigning miscellaneous M codes.
« on: December 18, 2012, 02:25:09 AM »
I have an old toolchanger that uses an array of relays as a logic board. The process of tool changing is done in stages and the following stage can only be achieved once a reset has been received by the controller to continue. The programming for this is done in M code and uses the redundant sets in the M-20 series. My question is: is it possible to programme this series of M commands (M20,  21, 22.... .... 28 etc.) to I/O's in Mach 3?

Pages: 1