Hello Guest it is March 29, 2024, 09:59:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kvnnos

Pages: 1
1
Hi,

I am using a motion card from leafboy77 (http://leafboy77.com/index.php/en/) and Windows 7 in my PC. During the working procces, my PC, shut down unexpected.

I isolated the PC to check it up, if I had problem with Windows 7 or with power supply. Nothing, PC is working fine.

Does anyone have same problem with me? With or without this specific motion card.

Thank you. 

2
Brains Development / Re: brain for safery guards?
« on: January 28, 2013, 01:20:17 AM »
thank you a lot!  ;)

3
Brains Development / brain for safery guards?
« on: January 27, 2013, 04:50:23 AM »
hi

I have enabled input 1 for safety guards and I have input from safety guard from my cnc.

I need a brain that when I loose input from safety guards mach3 stops everything and alarms.

Have some ideas?

Thank you

4
hi,
I wonder if i can connect a usb control board for 4 axes, + an ethernet control board to control 0-10V the spindle speed + a wireless usb pendant.

Is that posible?




5
dspMC/IP Motion Controller / Re: Servo direction
« on: December 01, 2012, 07:17:49 AM »
I use ActiveCube inverter from Bonfiglioli (not step/dir controlled).

DSPMC need encoder for feedback if i use analog output and I don't have. I have closed loop servo - inverter with resolver.

I will try without encoder feedback.


6
dspMC/IP Motion Controller / Re: Servo direction
« on: November 30, 2012, 08:31:40 AM »

7
dspMC/IP Motion Controller / Servo direction
« on: November 28, 2012, 11:09:21 AM »
Hello,

I have DSPMC V2. How i can give direction to inverter that have two digital inputs, one for each direction? I use Mach3. I know that Mach3 use pulse for step/dir but i have inverter with 2 digital inputs for direction and one analog 0-10V to control the speed of servomotor.

Thank you

Pages: 1