Messages

1

General Mach Discussion / Re: Probe-It probing wizard - 2D perimeter probing

« on: March 07, 2014, 05:00:04 PM »

has anyone tried this with machstdmill I like the idea of this and would like to use it with mach standard mill

Thanks andrew

2

Third party software and hardware support forums. / Re: OK now i need to get hold of Bob Campbell

« on: October 09, 2013, 02:54:57 AM »

Bob has contatcted me and is shipping a new chip first class service

Thanks

3

PoKeys / Is there a begineers guide to pokeys

« on: October 08, 2013, 07:10:07 PM »

I have a mill that has two parallel cables can pokeys replace this  i use inputs for limit's speed feedback tool height and probe plus the normal outputs XYZ A  motor control and coolant thanks

Andrew

4

Third party software and hardware support forums. / OK now i need to get hold of Bob Campbell

« on: October 08, 2013, 06:05:59 PM »

I ve been told i need to get hold of bob for a replacment chip for my combo board anyone have any idea as the bobcampbelldesigns email is a no go any help would be good

Thanks Andrew

5

Third party software and hardware support forums. / Trying to contact James Cullins of sound logic

« on: October 06, 2013, 07:17:59 PM »

as above as i need a new pic 16f818 for my combo board made by sound logic any help is apreciated as I think i killed the chip it got a tiny bit hot

Thanks All andrew

6

General Mach Discussion / Re: OT. Thread charts

« on: May 20, 2012, 02:27:11 PM »

thanks for that hood have now them at http://pages.cs.wisc.edu/~bolo/workshop/thread.html

incidently the bridgeport stepper motors i brought off you are still going great

Thanks andrew

7

General Mach Discussion / OT. Thread charts

« on: May 18, 2012, 06:08:52 AM »

I have in my workshop a set of thread charts listing quite a few different types of threads listed in size order that I downloaded a few years ago but now I can remember where I got them from they list the pitch major minor both in imperial and metric any one have the link
very usefull for thread milling ect
Thanks Andrew

8

General Mach Discussion / cant open notepad in mach 3

« on: April 11, 2012, 05:35:07 PM »

As the title says when I hit edit g code a small window opens (not notepad ) and then closes again and the code refreshes and that's it it worked in the  past until I tried Mach standard screen and now im back to the old one it dosnt any help please

Thanks Andrew

9

General Mach Discussion / Re: upside down help

« on: February 10, 2008, 02:28:42 PM »

the problem was I just needed to click my display mode button

thanks for the help though

andrew bishop

10

General Mach Discussion / Re: upside down help

« on: February 06, 2008, 03:47:01 PM »

OK found problem and am to embarrassed to say what it was but thanks for the help
Andrew