Hello Guest it is November 27, 2020, 06:34:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - eelmans

Pages: 1
1
General Mach Discussion / Re: used encoder for feedback
« on: November 26, 2012, 06:01:36 AM »
Who is accountable?

2
General Mach Discussion / Re: used encoder for feedback
« on: November 23, 2012, 06:00:40 AM »
I want to count axis DRO with encoder pulse and No with calculation.
for example ,
X Axis will continue to move until X position Encoder  reaches to the destination coordinates .

3
Thank you for the answer.
I've attached the XML file.
When each of  input and limit switch is activated, Each output may change.

4
General Mach Discussion / used encoder for feedback
« on: November 23, 2012, 01:50:03 AM »
I'm going to use the encoder for feedback on  x,y axes. So the encoder position of  axes appear directly to axes DRO.
What should I do?

5
General Mach Discussion / toolpath is incomplete
« on: November 23, 2012, 01:14:16 AM »
Mach3 v3.043.022  and  v3.043.053   is displayed in the toolpath is incomplete.
And while the gcode in Mach3 v2.63 is displayed complete.
What should I do to fix this problem?

6
I am using Mach3 v2.63  software.
When an input is activated Unwanted output changes.
Please Help me.

Pages: 1