Messages

1

Third party software and hardware support forums. / Re: connecting plasma torch

« on: November 19, 2012, 09:22:31 AM »

So I'm gonna ask the same question since Nigel figured it out, but I haven't.  I have a TB6560 BoB with all the steppers working through MACH3, but this question is the last sticking point for me.  How do I physically wire from the BoB to my Plasma Cutter, the "switch" connection on/off button to get it to turn on on command from MACH3 via the BoB (Break out Board).

Thanks in advance for the help.