Messages

1

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 18, 2012, 08:28:00 AM »

found this

2

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 18, 2012, 08:05:03 AM »

Hood . i'll send you what i got

3

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 17, 2012, 11:50:09 AM »

Hood,
The spindle driver is a Delta VFD-M 220V 1.5kW
Motor is a Mav3 80-4, 1.5hp, 1.1kW, 4 pole, 220V
Thats the best I can do, thanks for your help.

4

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 16, 2012, 07:29:51 PM »

Hood , here's the last xml , thanks for looking at it , I do appreciate the help !!

5

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 16, 2012, 06:51:33 AM »

i'm not at the site , won't be there till 3pm my time , working my day job in a tool room

6

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 16, 2012, 06:18:16 AM »

Hood , you guys were right , i reversed x home & y home and it correctly homed out . That xml file is the one i started with , just having to try to  get things working one step at a time , next is getting spindle to stay on , command  s100m3 and spindle turns on , runs a couple seconds and stops ,,,,, this is a learning experience !!

7

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 15, 2012, 04:28:15 PM »

Hood , something is changing , i saved on notepad i'll try sending the internet file

8

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 15, 2012, 04:25:41 PM »

See if this works

9

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 15, 2012, 03:30:33 PM »

Hi Hood !
 I was home and had the wrong info .  X=M1 home   Y=M2 home   Z=M3 home    ,  I attached the xml file here for you that i used,,, thanks for looking !

10

General Mach Discussion / Re: M4a & Mach3 startup ???'s

« on: November 15, 2012, 06:00:00 AM »

Thanks i'll try that this afternoon
   Steve