Hello Guest it is March 28, 2024, 05:39:34 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - drivetrain2

Pages: 1
1
General Mach Discussion / Re: limit switches work and dont work i need help
« on: November 13, 2012, 06:29:31 PM »
no (off and on) but when it works it works till i start it up again
yes
pmdx-126
where would it be in the controll box
not sure what debounce is
not sure
there is a emi filter on the plug to the control box
the box has a ground inside for the control box...
the kit is a cnc router parts nema  34 built by them
 can you pm me with info and i will send pics from my phone
thanks keith

2
General Mach Discussion / limit switches work and dont work i need help
« on: November 11, 2012, 05:14:28 PM »
I bought a cnc router parts 4x4 machine.  I added proximity switches to the xyz axis (USED FOR HOMING AND LIMITS THE SAME SWITCH).  I keep on getting an intermittent limit switch alarm on the z axis than the y acts up.  Mach 3 is the only system running while the machine is on.  I play with the machine for about 30mins and than it works the rest of the day.(turn the machine and computers on and off,turn the limit switches off)  I also tried to separate the motor wires from the limit switches wires.   I NEED HELP

Keith

Pages: 1