Messages

1

General Mach Discussion / Re: Requested home switch is active...please fix, then home

« on: November 07, 2012, 11:53:01 AM »

I have some extra switches, should I try to replace the one on the z-axis and the re-reference the table.  I have referenced the table a couple of times since this started and it will work right for sometimes 1 or sometimes up to 50 cuts but then the messages will come back.

2

General Mach Discussion / Re: Requested home switch is active...please fix, then home

« on: November 07, 2012, 08:35:26 AM »

HOME switch?  is that the limit trigger switch on the Z-axis?

3

General Mach Discussion / Requested home switch is active...please fix, then home

« on: November 06, 2012, 03:58:44 PM »

I don't know what this means.  When the message appears the light next to the Z-axis readout turns from green to red and the z-axis on the table goes all the way up.  I can reference all axis, switch to the coordinates button and sometimes I will not get the message and all is good and then the next time its not.  I have an EZ-Router APC plasma table.  Any and all assistance is greatly appreciated.