Hello Guest it is March 28, 2024, 12:54:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnnyg

Pages: 1
1
General Mach Discussion / Re: Mach 3 Roadrunner.
« on: November 07, 2012, 12:51:54 PM »
where do I find the roadrunner file?

2
General Mach Discussion / Setup Of New Breakout Board
« on: October 19, 2012, 01:33:06 PM »
I bought this board here http://www.ebay.com/itm/200763845425?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649 and am having some problems trying to set it up to work with mach3 2.0 I have some pictures of all what i have so far. I have X Axis and Z Axis motors turning forward and reverse and stalling sometimes but no Y Axis turning. X Axis and Z Axis Motors also seem to be locked up when you start Mach3 you can't turn the shaft by hand but you can turn the Y Axis motor. Also the X Axis and the Z Axis motors seem to be getting hot when they are not running any code and just sitting there. What is causing the motors to overheat and why does the Y Axis not move? I have more pictures but it won't let me post more than 4. Why is that more problems now not enough with what I have to do?

Pages: 1