Hello Guest it is March 29, 2024, 04:26:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - vasco.carvalho

Pages: 1
1
Hello I'm using a DSPMC-V2 and MACH3. I already have motors, connectors etc... everything works well.
But, now I need read a analog input and I don't know how.
I'm using the pin "analog input 0" of the connector "J2-ANALOG I/O".

Thank you
Vasco Carvalho
Portugal

2
General Mach Discussion / Read an analog input from DSPMC-V2 with MACH3
« on: October 09, 2012, 06:50:28 AM »
Hello I'm using a DSPMC-V2 and MACH3. I already have motors, connectors etc... everything works well.
But, now I need read a analog input and I don't know how.
I'm using the pin "analog input 0" of the connector "J2-ANALOG I/O".

Thank you
Vasco Carvalho
Portugal

Pages: 1