Hello Guest it is March 29, 2024, 06:22:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - minibuggy

Pages: 1
1
General Mach Discussion / Rotate a rotary axis in one direction only
« on: July 13, 2015, 02:11:35 PM »
Does anyone know how to get a rotary axis to only operate in only the positive direction?  It would roll over 360 and still move positive no matter what angle is commanded?

2
Hello,

Apologies if this is in the wrong place.

I am trying to implement a button on the standard Mach 3 screenset, that changes the active hi state of the probe input.  I have a probe and a tool height sensor that are sharing an input.  One of them acts as an NC switch, and the other as a NO switch.  As opposed to going into ports and pins to change the pin active state of the probe in anytime I want to switch probe function, I am curious if I can add a button to the Program Run screen to accomplish this repeated task.  Is this possible, and can someone point me in the right direction to implement it?

Thanks.

Pages: 1