Messages

1

General Mach Discussion / AKZ250 - USB controller Problem

« on: November 19, 2012, 08:50:25 AM »

Here is a test i am doing.
It show a communication problem with the USB controller.

When i click and move the 3D view in Mach3, the controller stop working randomly (on-off) you can hear the CNC start and stop in the video to the point it completly stop.
I can produce the problem like that but i get errors while cutting and not touching anything too.

I have try that on 3 different PC.
2 where 8years old desktop with single core processor and they make the same error.
Last was my i7 quad core laptop and that one work flawlesly...

http://www.youtube.com/watch?v=sOjsXQ5YgrU

Anybody know the problem...

I am shopping for a new pc and would like to be sure that it will work.

ZOTAC D2700-ITX
http://www.zotacusa.com/zotac-d2700-wifi-supreme-d2700itxs-a-e.html

Thanks all

Eric

2

Third party software and hardware support forums. / Re: Android Phone-Tablet - Mach3 control

« on: October 04, 2012, 08:41:36 AM »

Found an app called gpad.
It's a pc remote that have a customizable screen

3

Third party software and hardware support forums. / Android Phone-Tablet - Mach3 control

« on: October 03, 2012, 10:12:54 PM »

Hi,

I was searching the web and didn't found much.
Would like to use an Android device to "Jog" move my CNC.

Having the opportunity to change the Jog speed would be a must.

Anybody know something..??

Thanks a lot