Hello Guest it is March 29, 2024, 09:15:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - surfmike

Pages: 1
1
General Mach Discussion / Re: Irregular height of material possible?
« on: September 27, 2012, 12:16:56 PM »
Thanks Dave,

you've been to great help.

//Mike

2
General Mach Discussion / Re: Irregular height of material possible?
« on: September 25, 2012, 03:57:24 PM »
Thanks Dave!

So there is an option to enter WHERE the material actually is in Gcode format? Any particular CAM program in mind?
I feel my learning curve is steep from zero... :)
//MIke

3
General Mach Discussion / Irregular height of material possible?
« on: September 25, 2012, 01:29:22 PM »
Hi! I'm new in this cnc area, so I need some advice from the guys who do know...

I want to mill some 3D stuff which is very irregular in height and volume.
In some areas it's a lot of material, in some areas it's minor. Total area is approx. 4' x 8' (48"x96") (120x240cm).

Is it possible to stack material in different height (see attached picture) depending on where it's needed, and tell the program/machine/Mach3 to work just where the material is placed?

Thx
//Mike

Pages: 1