1
General Mach Discussion / limit switch detection mach3
« on: September 19, 2012, 11:55:16 AM »
I am trying to set up mach3 on a simple tabletop 3 axis nc router that is working on mach2.
+ and - limit switches are shared pin with homing on each axis
I cant get mach 3 to detect the switches. I started with what I thought was the same setup as Mach2, and tried several variations without success.
Is there something I am missing? can someone give me a setup checklist?
Thanks Craig
+ and - limit switches are shared pin with homing on each axis
I cant get mach 3 to detect the switches. I started with what I thought was the same setup as Mach2, and tried several variations without success.
Is there something I am missing? can someone give me a setup checklist?
Thanks Craig