1
General Mach Discussion / Re: Can read THC input signals but spindle doesn't move
« on: September 28, 2012, 12:55:53 PM »
I found an old computer with parallel port and connects directly my SmoothStepper and it works.
The problem comes from the USB to parallel converter that was between my computer and the SmoothStepper.
I'll try another converter if I find some time.
Thank you for your help bad_bunny!
Garf
The problem comes from the USB to parallel converter that was between my computer and the SmoothStepper.
I'll try another converter if I find some time.
Thank you for your help bad_bunny!
Garf