Hello Guest it is November 12, 2019, 08:45:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - petenunez

Pages: 1
1
Greetings to all;

   My name is Pete Nunez and I am new to the forum and also new to CNC. I recently purchased a Phlatprinter 3, a hobby grade cnc machine which is powered by a Gecko G540 using Mach3. I was wondering if anyone could tell me or point me in the right direction in regards to the calibration of this machine. So far all systems perform well, with very few bugs, however it would be great to learn how to go about the calibration procedure.

  thank you, hope hear from all of you soon;

  Pete

Pages: 1