1
General Mach Discussion / Re: Denford Microrouter V3 conversion to Mach3
« on: August 29, 2012, 09:28:43 AM »
Many thanks for the advice.
I have now ordered a breakout board and spindle driver from DIYCNC, along with a few components from Farnell Electronics to access the 96pin header.
I will keep this thread posted on how I get on.
Graham
I have now ordered a breakout board and spindle driver from DIYCNC, along with a few components from Farnell Electronics to access the 96pin header.
I will keep this thread posted on how I get on.
Graham