Hello Guest it is March 29, 2024, 06:46:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ooyeap

Pages: 1
1
General Mach Discussion / using vector art 3d files
« on: December 12, 2012, 04:04:24 PM »
Has anyone created a toolpath with the website's free vector art machinist software?  If you have, does anyone know how to import a saved toolpath into mach 3 software.

thanks
jeff
alabama

2
General Mach Discussion / Problem with the engraving wizard
« on: November 21, 2012, 01:26:10 PM »
Guys,

Somtimes when i using the engraving wizard my letters route on top of each other. but not all the time. anyone have any ideas?

3
General Mach Discussion / Re: mach 3 comm port
« on: September 06, 2012, 06:04:07 PM »
is there a sheet somewere that tells me were everything supose to be?

4
General Mach Discussion / Re: mach 3 comm port
« on: September 06, 2012, 05:12:45 PM »
thanks,

ok got all that.    I wish you were down the road...lol

Any ideas on how the limited switch's  in the ports and pins should look like.. i cant get my e-stop to reset. i'am just a big mess here...

5
General Mach Discussion / Re: mach 3 comm port
« on: September 06, 2012, 04:40:15 PM »
Thanks for your help in my device manager its says i'am plunged into LPT1.   but into mach3 config, do i just change the com port # to "1"

6
General Mach Discussion / mach 3 comm port
« on: September 06, 2012, 02:27:42 PM »
Could someone help me out. Could someone screen shot me a pictures on how the mach3 comm. port is set up. is it com 1 or is it LPT 1.  please help.

jeff parrott
334.296.2353 alabama

7
General Mach Discussion / using a printer port
« on: September 04, 2012, 11:13:22 AM »
Please help.

Could anyone help me with some screen shots on how mach 3 is set up using the printer port.  i have my cable in the LP1 slot on back of the machine. but when i look into the config page of mach 3 i think it says iam suppose to be using com1.  It was running ok last week before my comp. udated itself. Could someone please help a dummy out. thanks jeff   334-296-2353

8
General Mach Discussion / New License key
« on: August 01, 2012, 01:47:30 PM »
I need someones help. i just recieved my new mach3 license key from artsoft.  I understand it needs to go into the main mach3 folder. But my question is were does it need to be placed. There are about 10 folders and about 30 misc files. i just added it right along with the misc files. but when i open mach3 up it still shows demo mode and not my name.  someone please help.

thanks
Jeff in Alabama
334-296-2353

Pages: 1