Hello Guest it is March 29, 2024, 09:34:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - YAMANEKO

Pages: 1
1
General Mach Discussion / Re: question about "Mach3 Addons for Mill"
« on: July 11, 2012, 01:30:22 AM »
Oh,,,
I upgraded the addon to 2.86, and now it works perfectly!
I decided to purchase this fine addon. thank you!

2
General Mach Discussion / Re: question about "Mach3 Addons for Mill"
« on: July 11, 2012, 12:58:02 AM »
Thank you!
I tried doing POST CODE and VERIFY TOOLPATH, then it works fine!
Maybe, is it a problem related to only preview?

By the way,
I found difference on Groove function.
There are two screenshots, one is "Cut Circle" with Groove on/off, and another is "Cut Rectangle". It seems Groove option is not functioning at "Cut rectangle".

3
General Mach Discussion / Re: question about "Mach3 Addons for Mill"
« on: July 10, 2012, 12:15:16 PM »
OK, I have two screen shots.
Its depth step looks too small than the value I set.
Also, there is a strange curve in the bottom, this will break the end mill certainly.

4
General Mach Discussion / question about "Mach3 Addons for Mill"
« on: July 10, 2012, 07:23:25 AM »
I'm considering to purchase "Mach3 Addons for Mill" now, but is this work correctly?
Choose "mm" as unit, select "Cut Rectangle", enter dimensions, and 2 as Depth and 0.5 as Step Depth, and do preview. Is the result correct?

Pages: 1