Messages

1

General Mach Discussion / Re: Mach3 automatic tool changer

« on: December 16, 2014, 12:04:50 PM »

Hi I want to run 4 station electric tool changer LD4 can anybody help me how to configure macro ,brain and VB

2

General Mach Discussion / Re: Additional Spindle control

« on: December 16, 2014, 11:55:25 AM »

do you have internet so i can mange properly

3

General Mach Discussion / Re: Additional Spindle control

« on: December 16, 2014, 11:54:04 AM »

hi i can help you please tell me exact wat you need

4

General Mach Discussion / Re: USB Breakout board for Mach3

« on: December 30, 2012, 03:58:51 AM »

another one is that when i pressed emergency stop button then mach3  shows me urgency stop alarm instead of e stop requested. and when i use limit switch that time it shows me limit stop instead of limit switch triggered.
is there any option to change alarm script in mach3?

5

General Mach Discussion / Re: USB Breakout board for Mach3

« on: December 30, 2012, 03:46:15 AM »

hi every body

actually i am also installing Xulifeng USB board on mach 3. i have one problem .
 
can anybody tell me in that board for input we have to take external 5v or internal provided.

and another one is that for that board which pin number for charge pump?

6

SmoothStepper USB / Re: Trouble with smooth stepper

« on: July 15, 2012, 04:15:28 AM »

Hi
Hood, Actually i re tuned motors again but i got same result.

Is there any changes in ss config? so i can change?

7

SmoothStepper USB / Re: Trouble with smooth stepper

« on: July 14, 2012, 07:01:00 AM »

Because of that things, i tried with schnider motors and drives also but the pitch variation is showing same.

8

SmoothStepper USB / Re: Trouble with smooth stepper

« on: July 14, 2012, 06:48:12 AM »

I am using panasonic servo drives and servo motor. (2.4 Nm)

9

SmoothStepper USB / Re: Trouble with smooth stepper

« on: July 14, 2012, 06:13:21 AM »

i am using servo motors for  x &z axes as well as using rolled ballscrew C7 grade.

10

SmoothStepper USB / Re: Trouble with smooth stepper

« on: July 14, 2012, 05:19:23 AM »

hi Hood

 i tried with M49 before the threading code but it shown up to 1mm pitch shifting.