Hello Guest it is May 28, 2020, 08:00:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TomTom

Pages: 1 2 3 4 5 »
1
General Mach Discussion / Re: Changing cut order. plasma
« on: October 17, 2012, 01:17:29 PM »
Thanks. That did the trick. :)

2
General Mach Discussion / Re: Changing cut order. plasma
« on: October 17, 2012, 01:27:16 AM »
Thanks. Tinkered with it all evening and never could change the cut order. :(

3
General Mach Discussion / Changing cut order. plasma
« on: October 16, 2012, 04:28:33 PM »
Trying to cut a circle with 4 holes inside. It cuts 3 inside holes then the perimeter then goes to the last inside hole.   I have cut inside first checked in sheet cam. Thanks.

4
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 10:31:04 PM »
I really Appreciate the help. Cut out 2 parts and works like a charm. :)

5
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 08:41:07 PM »
It is a homemade table 48x48. I ran an ESAB shadow 500 and 1000 for about 10 years and never had to do any of the technical stuff. We called maintenance. lol. Decided to get this one so my wife cut cut the pretty yard decorations etc and here I am trying to get everything working right. I sure do appreciate the help. will be cutting mostly 12 and 14 guage. maybe some 20 guage stainless.

6
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 07:41:36 PM »

 :o I just don't want to mess nothing up. wife would not be happy. So if I want the torch closer to the table  1630 would go to 2000. ??



Steps per - 1630
Velocity - 90
ACC - 60
Gs - .155411424
Step pulse - 5
Dir pulse - 3


7
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 06:51:34 PM »
I went to Mach3 install/config last night and read, but where do I find that configuration?

8
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 05:10:17 PM »
Well now it is different (guess I done something else wrong, but it doesn't hit the sheet anymore. It cycles from the top of travel and stops  1 1/4  inches above the sheet. way too high but better  than it dragging on the metal. BTW.     Z  travels about one inch.
 I wish i could control the height manually!!

9
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 02:57:28 PM »
Need to get the Z to stop hitting the metal before it fires and drags on the sheet. Any ideas? Thanks.

10
General Mach Discussion / Re: Plasma -Easy question but got me stumped
« on: October 14, 2012, 02:56:27 AM »
And next I get to play with velocity. It makes a whinning noise while makeing a cut. :)

Pages: 1 2 3 4 5 »