Messages

1

General Mach Discussion / Re: uln2003 controller

« on: June 26, 2012, 10:42:44 PM »

https://www.virustotal.com/url/9ecc36acc9c65f5a11e28f8deeeb8269991e20983c751f75b5bec953a473866a/analysis/1340764934/

Above is a scan of the site by virus total... weird, it does not pick up anything...

2

General Mach Discussion / Re: uln2003 controller

« on: June 21, 2012, 08:13:46 PM »

  I don't know why your antivirus thinks it is bad... I have visited that website at least 200 times during the build of my CNC and have never had any problems.  I do however like you wiring schematic that you attached and I think that should work with the uln2003's.  How would I config MACH3 to work with that???

3

General Mach Discussion / Re: uln2003 controller

« on: June 21, 2012, 03:36:42 PM »

I think is is Phase Drive... here is a link to the instructions I followed making the driver.  http://colvins.ca/?p=11

4

General Mach Discussion / uln2003 controller

« on: June 21, 2012, 02:43:10 PM »

Hi everyone, this is my first post and I hope I put it in the correct place; If not I apologise.  My question is, will Mach3 work with my uln2003 controller, Here is a link to the schematic:  http://www.eleccircuit.com/wp-content/uploads/2008/05/uln2003-control-stepper-motor-by-parallel-port.jpg  I have this working with an older windows 98 dos cnc program called Turbo CNC.  But I would like to use something newer and better... Like Mach3.  So please let me know if Mach3 is compatible with my driver.