Messages

1

General Mach Discussion / Re: Installation problems

« on: June 17, 2012, 12:12:48 PM »

Thanks for the reply I found the pins and outputs in FAQ just a few minutes ago and that fixed the jog problem. I'll try the icons next.
thanks again

2

General Mach Discussion / Installation problems

« on: June 17, 2012, 11:33:38 AM »

I am using MACH3MILL_install_config.pdf to guide me through the installation of MACH3. The install goes well driver test program is ok, but the control screen has the end letters of many of the button names cut off and when I jog with arrows or buttons the readouts don't change. the other buttons work, but I am stuck here until I can figure this out.I have a 3gig pentium4 and 3 gig memory with two monitors. I have tried different screen settings, running MACH3 on either monitor. I have uninstalled and reinstalled the program twice. Also in MDI mode it doesen't run the lines and I can't delete them using esc.del, or backspace.

3

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: June 17, 2012, 11:12:57 AM »

Hi, I have been lurking on this site for about a year, and thought I would finally register. I have had some  cnc experience using a Fadal mill and I am going to build a mill/router using mach3. I am semi retired and live in Stillwater, OK.