Hello Guest it is May 17, 2021, 12:56:45 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - himpini

Pages: 1
VB and the development of wizards / Re: Macro for Rotary Tool Changer
« on: March 31, 2019, 06:07:10 PM »
Hi, sorry if I´m doing my question in a wrong way

I have a Takisawa Lathe working with Mach3
This lathe has te posibility to use 6 differents tools.
I´m working on a Macro to make a auto tool changer, but I´m a bit lost about how to do it.
The rotary tool works with the hydraulic system and not with a servomotor.
Here ther is a video to see how its works for a better understanding.


Could you help me with some Macro to check that could help me to finish my work?
Is there any document with help about Macros and examples?


General Mach Discussion / Error during first cycle start
« on: July 14, 2013, 07:26:42 PM »
Hello, I have Mach 3 Version R3.043.066 installed, since a few days i have the next problem,
WHEN i start mach 3 in my PC the first time, I load the file and when press the cycle start button the machine goes to any where. Dont respect the file
When this happens I stop, I go to zero, and press again cycle start and work ok

Does someone  had the same problem?

Thanks  lot

General Mach Discussion / Mach Turn 3D Toolpath
« on: July 02, 2012, 06:15:50 PM »
Hello, I am using Mach Turn in a Takisawa Lathe, I cant see in the toolpath screen the 3D screen likes shows the manual.
Can anyone help me with this??


Pages: 1