Messages

1

General Mach Discussion / motor steping

« on: June 06, 2012, 07:22:44 PM »

i have set my mach 3 to cut a grid on my table 2 inches apart both the y axis and the x axis direction,  the x axis cuts every 2inches like it should butt my y cuts every 1.5 my motors are set the same in the config motor tuning page i wounder if the y has the wrong Greer on it can any one help?   

2

General Mach Discussion / Re: z axis moving up

« on: June 06, 2012, 07:09:08 PM »

i have set up a grid on my table to drill holes every 2 inches in  the y and x axis when i run the mach 3 program the x cuts every 2 inches but the y only cuts every 1.5 the table display shows both axis cutting at 2 inches both my y and x axis motors are set the same in the motor tuning in the config page anyone have any ideas