1
General Mach Discussion / Re: Z Axis Stops Working / Fails To Move
« on: August 13, 2012, 09:18:45 AM »
Thanks Overloaded. Checked through all the wiring and connections and all looks good so don't think its the root cause of the issue I'm seeing here. I ran the program again over the weekend and the same thing happened (at a different point in the program) with the G0 Z3.0 return to safe Z command. It's a large 2.5D file with 450,000 lines so I can't really sit there and watch it continuously but I did catch what I think was the motor stalling when moving the Z and hence had to reset the Z height. By the time this had happend I was already through 20,000 lines of code so its definitly not a regular occurance and struggle to understand how it could be a motor tuning issue.
Any ideas?
Any ideas?